HP 6125XLG Configuration Manual page 173

cannot be automatically obtained from the destination IPv6 addresses of packets, configure an IPv6 over
IPv4 manual tunnel.
Figure 73 Network diagram
Configuration procedure
Make sure Switch A and Switch B have the corresponding VLAN interfaces created and can reach each
other through IPv4.
Configure Switch A:
•
# Specify an IPv4 address for VLAN-interface 100.
<SwitchA> system-view
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 192.168.100.1 255.255.255.0
[SwitchA-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 address 3002::1 64
[SwitchA-Vlan-interface101] quit
# Create service loopback group 1 and specify its service type as tunnel.
[SwitchA] service-loopback group 1 type tunnel
# Add Ten-GigabitEthernet 1/1/5 to service loopback group 1.
[SwitchA] interface Ten-GigabitEthernet 1/1/5
[SwitchA-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchA-Ten-GigabitEthernet1/1/5] quit
# Configure an IPv6 over IPv4 manual tunnel interface tunnel 0.
[SwitchA] interface tunnel 0 mode ipv6-ipv4
# Specify the source interface for the tunnel interface as VLAN-interface 100.
[SwitchA-Tunnel0] source vlan-interface 100
# Specify the destination address for the tunnel interface as the IP address of the VLAN-interface
100 on Switch B.
[SwitchA-Tunnel0] destination 192.168.50.1
[SwitchA-Tunnel0] quit
# Configure a static route destined for IPv6 network 2 through tunnel 0 on Switch A.
[SwitchA] ipv6 route-static 3003:: 64 tunnel 0
Configure Switch B:
•
# Specify an IPv4 address for VLAN-interface 100.
<SwitchB> system-view
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ip address 192.168.50.1 255.255.255.0
165