Multiport Arp Entry Configuration Example; Network Requirements; Configuration Procedure - HP 6125XLG Configuration Manual

# Create VLAN-interface 10 and configure its IP address.
[Switch] interface vlan-interface 10
[Switch-vlan-interface10] ip address 192.168.1.2 8
[Switch-vlan-interface10] quit
# Configure a static ARP entry that has IP address 192.168.1.1, MAC address 00e0-fc01-0000, and
output interface Ten-GigabitEthernet 1/1/5 in VLAN 10.
[Switch] arp static 192.168.1.1 00e0-fc01-0000 10 Ten-GigabitEthernet 1/1/5
# Display information about static ARP entries.
[Switch] display arp static
IP Address
192.168.1.1

Multiport ARP entry configuration example

Network requirements

As shown in
Ten-GigabitEthernet 1/1/6, and Ten-GigabitEthernet 1/1/7 in VLAN 10. The servers share the IP
address 192.168.1.1/24 and MAC address 00e0-fc01-0000.
Configure a multiport ARP entry to send IP packets with destination IP address 192.168.1.1 to the three
servers.
Figure 5 Network diagram

Configuration procedure

# Create VLAN 10.
<Switch> system-view
[Switch] vlan 10
[Switch-vlan10] quit
Type: S-Static
MAC Address
00e0-fc01-0000
Figure 5, a switch connects to three servers through interfaces Ten-GigabitEthernet 1/1/5,
D-Dynamic M-Multiport
VLAN ID Interface
10 XGE1/1/5
8
I-Invalid
Aging Type
N/A S