HP ProCurve Switch 6120G/XG Manual page 101

Web and MAC Authentication
Configuring Web Authentication
3-24
Syntax: [no] aaa port-access web-based <port-list>
Enables web-based authentication on the specified
ports. Use the no form of the command to disable web-
based authentication on the specified ports.
Syntax: aaa port-access web-based <port-list> [auth-vid <vid>]]
no aaa port-access web-based <port-list> [auth-vid]
Specifies the VLAN to use for an authorized client. The
Radius server can override the value (accept-response
includes a vid). If auth-vid is 0, no VLAN changes occur
unless the RADIUS server supplies one.
Use the no form of the command to set the auth-vid to 0.
(Default: 0).
Syntax: aaa port-access web-based [clear-statistics]
Clears (resets to 0) all counters used to monitor the
CEI, HTTP, Web-Auth control traffic generated in web
authentication session. (To display Web-Auth traffic
statistics, enter the show port-access web-based statis-
tics command.)
Syntax: aaa port-access web-based <port-list > [client-limit <1-32>]
Specifies the maximum number of authenticated cli-
ents to allow on the port. (Default: 1)
Note: On switches where Web Auth and 802.1X can
operate concurrently, this limit includes the total num-
ber of clients authenticated through both methods.
Syntax: aaa port-access web-based [dhcp-addr <ip-address/mask>]