Configure The 802.1X Authentication Method - HP ProCurve Switch 6120G/XG Manual

Configuring Port-Based and User-Based Access Control (802.1X)
Configuring Switch Ports as 802.1X Authenticators
Figure 10-6. Example of 802.1X (Port-Access) Authentication
10-24

3. Configure the 802.1X Authentication Method

This task specifies how the switch authenticates the credentials provided by
a supplicant connected to a switch port configured as an 802.1X authenticator
You can configure local, chap-radius or eap-radius as the primary password
authentication method for the port-access method. You also need to select
none or authorized as a secondary, or backup, method.
Syntax: aaa authentication port-access <chap-radius |eap-radius | local>
Configures local, chap-radius (MD5), or eap-radius as the primary
password authentication method for port-access. The default pri-
mary authentication is local. (Refer to the documentation for
your RADIUS server application.)
For switches covered in this guide, you must use the
password port-access command to configure the operator user-
name and password for 802.1X access. See "General Setup Proce-
dure for 802.1X Access Control" on page 10-14 for more
information.
[<none | authorized >]
Provides options for secondary authentication. The
none option specifies that a backup authentication
method is not used. The authorized option allows access
without authentication. (default: none).
For example, to enable the switch to perform 802.1X authentication using one
or more EAP-capable RADIUS servers:
Configuration command
for EAP-RADIUS
authentication.
802.1X (Port-Access)
configured for EAP-
RADIUS authentication.