Option For Authenticator Ports: Configure Port-Security To Allow Only 802.1X-Authenticated Devices - HP ProCurve Switch 6120G/XG Manual

Option For Authenticator Ports: Configure Port-Security To Allow Only 802.1X-Authenticated Devices

Figure 10-8. Port-Access Support for Port-Security Operation
The first client to authenticate on a port configured to support multiple
■
clients will determine the port's VLAN membership for any subsequent
clients that authenticate while an active session is already in effect.
Option For Authenticator Ports:
Configure Port-Security
To Allow Only 802.1X-Authenticated
Devices
If 802.1X authentication is disabled on a port or set to authorized (Force
Authorize), the port can allow access to a non-authenticated client. Port-
Security operates with 802.1X authentication only if the selected ports are
configured as 802.1X with the control mode in the port-access authenticator
command set to auto (the default setting). For example, if port A10 was at a
non-default 802.1X setting and you wanted to configure it to support the port-
security option, you would use the following aaa port-access command:
Configuring Port-Based and User-Based Access Control (802.1X)
Control mode
required for Port-
Security Support
10-45