Configuring The Switch For Ssl Operation; Assigning A Local Login (Operator) And Enabling (Manager) Password - HP ProCurve Switch 6120G/XG Manual

Configuring the Switch for SSL
Operation
SSL-Related CLI Commands in This Section
web-management ssl
show config
show crypto host-cert
crypto key
generate cert [rsa] <512 | 768 |1024>
zeroize cert
crypto host-cert
generate self-signed [arg-list]
zeroize
1. Assigning a Local Login (Operator) and
Enabling (Manager) Password
At a minimum, ProCurve recommends that you always assign at least a
Manager password to the switch. Otherwise, under some circumstances,
anyone with Telnet, web, or serial port access could modify the switch's
configuration.
Using the web browser interface To Configure Local Passwords. You
can configure both the Operator and Manager password on one screen. To
access the web browser interface, refer to the chapter titled "Using the
ProCurve Web Browser Interface" in the Management and Configuration
Guide for your switch.
Configuring Secure Socket Layer (SSL)

Configuring the Switch for SSL Operation

Page
page 7-19
page 7-19
page 7-12
page 7-10
page 7-10
page 7-10
page 7-10
7-7