Whirlpool SDRY60 Operation Manual page 8

INSTALLATION INSTRUCTIONS
2.Fix the wall hanging brackets to the wall securely (eg. into the stud).
If the studs are too far apart, fit a timber slat to the studs then mount the
brackets onto the slat. The distance between each is 553 mm as per
diagram (Fig.1).
Fig.1
Warning: Ensure that the screw and nut of the Wall Hanging Brackets are
tightened during installation, if required. Regularly check all the
screws and nuts and tighten, if required. Do not overtighten.
3. Keep the exhaust grill at front of the dryer, then install the hooks
to the dryer, in the inverted position. Remove the 2 screws and
2 plastic plugs as indicated in Fig.2.
Fig.2
4. Align the hooks as shown in fig.3 and refit screws tightly. Install the
spacers provided in Fig.3.
Fig.3
553 mm
2 screws
2 plastic plugs
3 screws
2 spacers
6
Wood screw
2 hooks