Inverted Wall Mounting - Whirlpool SDRY60 Operation Manual

Free standing
The dryer stands on the floor and can easily be moved into position. Ensure
that it is placed on a level floor. Also ensure there is at least 50 mm air
clearance between the back of the dryer and the wall to allow fresh air flow
for efficient operation even using the front venting option.

Inverted wall mounting

The dryer can be mounted on the wall in the inverted position only by following
these instructions.
Invert the dryer so that the control panel is at the bottom (see figure 4) this
allows easier access to the controls.
1. Determine the location of the dryer on the wall and mark the bracket
position.
A minimum 50 mm is needed between the top of the dryer and the ceiling
for ease of installation;
If mounting above a washing machine, allow sufficient room to open the lid
of the washer.
Tools required
For plaster/ Drill & 3mm Bit
Wooden wall Philips head screwdriver
Wall mounting kit includes
Plastic spacers
Wall hanging brackets
Hanging hook
Description
Wood screws, 12gx50mm
Screws for hanging hooks
and plastic spacers.
INSTALLATION INSTRUCTIONS
Attention:
Please don't put a heavy
load on the dryer's top panel,
such as a basketry full of
wet laundry.
5
1
1
2
2
2
4
6
Minimum lid
clearance