Stacking Installation - Whirlpool SDRY60 Operation Manual

5.With assistance, mount dryer on wall brackets. See Fig.4.
6. A second control panel film with inverted symbols is supplied. To fit this film,
pull off the knob and then remove the old film.
Peel the release paper from the back of inverted film, then place new control
panel film on the surface so that the writing is the correct way around.
7. Press the Start/Pause button and hold it in the pressed position, and at the
same time, turn the program dial knob from the OFF position to any other
program, until the inversion is displayed.
Caution:
Plug must be accesible after installation.

Stacking installation

You can use a stacking kit (included as an accessory) if you want to mount your
dryer on the top of a Whirlpool front load washing machine, ensure the washer is
the same width as the dryer.
1. Remove 4 screws among screws on the bottom panel (see fig.1), and install
the stacking kit on the bottom panel (see fig.2).
Fig.1
INSTALLATION INSTRUCTIONS
4 Screws
7
Fig.4
stacking kit
Fig.2