Connecting The Speaker Output Terminals - Pioneer GM-5400T Owner's Manual

Connecting the units
1 Positive (+) terminal
2 Engine compartment
3 Vehicle interior
4 Fuse (30 A) × 2
5 Insert the O-ring rubber grommet into the
vehicle body.
6 Drill a 14 mm hole into the vehicle body.
2 Twist the battery wire, ground wire
and system remote control wire.
3 Attach lugs to wire ends. Lugs not sup-
plied.
Use pliers, etc., to crimp lugs to wires.
1 Lug
2 Battery wire
3 Ground wire
4 Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
1 System remote control terminal
2 GND terminal
3 Power terminal
4 Terminal screws
Twist
5 Battery wire
6 Ground wire
7 System remote control wire
Connecting the speaker
output terminals
1
using nippers or a cutter by about 10 mm
and twist.
2
not supplied.
Use pliers, etc., to crimp lugs to wires.
Expose the end of the speaker wires
Attach lugs to speaker wire ends. Lugs
Section
03
Twist
9
En