Connecting The Speaker Output Terminals; Installation - Pioneer GM-ME600X6 Owner's Manual

1 Positive terminal
2 Battery wire (sold separately)
The maximum length of the wire between the
fuse and the positive
tery is 30 cm (12 in.).
3 Fuse (80 A) (sold separately)
Each amplifier must be separately fused at
80 A.
control wire to expose about 10 mm
wires.
3 Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
4
3
1 Battery wire
2 Power terminal
3 Ground wire
4 GND terminal
5 System remote control wire
6 System remote control terminal
7 Terminal screws
terminal of the bat-
Twist
10 mm (3/8 in.)
7
6
2
1
5
Connecting the speaker output
terminals
and then twist the wire.
2 Connect the speaker wires to the
speaker output terminals.
Fix the wires securely with the terminal
screws.
1
1 Terminal screws
2 Speaker wires
3 Speaker output terminals

Installation

WARNING
To ensure proper installation, use the supplied
parts in the manner specified. If any parts
other than those supplied are used, they may
damage internal parts of the amplifier or
become loose, causing the amplifier to shut
down.
Do not install in:
— Places where injury could occur if the boat
stops suddenly.
— Places where it may interfere with the
boat's operation.
En
Twist
10 mm (3/8 in.)
3
2