Connecting The Speaker Output Terminals - Pioneer 422070 220V Owner's Manual

Connecting the units
5 Insert the O-ring rubber grommet into the
vehicle body.
6 Drill a 14 mm hole into the vehicle body.
2 Twist the battery wire, ground wire
and system remote control wire.
3 Attach lugs to wire ends.
Use pliers, etc., to crimp lugs to wires.
1 Lug (sold separately)
2 Battery wire
3 Ground wire
4 Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
1 System remote control terminal
2 Ground terminal
3 Power terminal
4 Terminal screws
5 Battery wire
6 Ground wire
7 System remote control wire
Connecting the speaker
Twist
output terminals
1
strip the end of the speaker wires to ex-
pose about 10 mm of wire and then twist
the wire.
2
Use pliers, etc., to crimp lugs to wires.
1 Lug (sold separately)
2 Speaker wire
3
speaker output terminals.
Fix the speaker wires securely with the term-
inal screws.
Use wire cutters or a utility knife to
Attach lugs to wire ends.
Connect the speaker wires to the
Section
03
Twist
9
En