Table of Contents
Advertisement
OPERATING THE M40
Tape Monitor (Audio Recording)
In Standby or with the M40 power ON, press the Tape Monitor
button on the M40 Front Panel or Tape-M button on the M40
Remote to select the rear panel Tape IN/OUT. With a three-
head tape deck or other device capable of outputting the
actual recorded signal, this selection allows listening to the
output of an audio recording device, while it is recording, to
confirm the quality of the recorded signal.
1. Select the Source to be recorded by pressing that source
button on the M40 Front Panel or Remote. The Source
will be displayed in the Front Panel Display as shown in
Diagram 33.
2. Press the TAPE Monitor button on the M40 front Panel
or TAPE-M button on the M40 Remote to insert the Tape
IN/OUT Loop. TAPE M will flash slowly on the Front Panel
Display to indicate Tape Monitor is the signal being played
at the speakers.
3. With the source to be recorded playing, (Tuner active, CD
Play, etc) start the record process as appropriate on the
audio recorder connected to the TAPE M Loop. A three-
head recorder will output the recorded signal for monitor.
(A standard two head recorder will typically pass the input
signal through ti its output while recording.)
4. To listen to the recorded content, after recording is fin-
ished, play the recorded content from the audio recorder
via the TAPE M IN.
Reset
In unusual circumstances, it may be necessary to reset the M40 microprocessor. After a power outage or surge, the M40 may not
fully restore to normal operation. It may also be used to reset the M40 to factory defaults.
Note: Resetting the M40 by pressing the Preset Scan and Mute buttons will delete all Preset Channel Programming.
1. Turn the Main Power Switch on the M40 Rear Panel OFF.
2. Unplug the Power Cord for at least three minutes. Plug the Power Cord back in to the unswitched 110V AC outlet. Turn the
Main Power Switch back ON and try to operate the M40. If it is still not operating properly, proceed with the following Reset
Instructions.
3. Set the M40 to Standby. (ON/Standby button backlight red)
4. Press the Reset button on the M40 Rear Panel. Try M40 functions. If still not properly functional proceed to Step 5.
5. With the M40 in Standby, press and hold the M40 Front Panel Preset Scan and Mute buttons until the Firmware version ap-
pears on the Front Panel Display. Release the buttons. The display will flash a few times and turn off. The M40 will restore to
Standby. If the M40 still does not function properly, call Proficient Technical Support at 877.888.9004.
Please remember Reset will clear all Tuner Preset programming.
TUNED STEREO
SP. A
Diagram 33 Tape Monitor
30
TAPE
M
MHz
M40 Front Panel
M40 Remote
PRESET CH.
Hide quick links:
Advertisement
Table of Contents
