Selecting A Source; Operating The Tuner - Proficient Audio Systems M40 User Manual

Selecting a Source

In Standby or with the M40 power ON, press one of the Source
buttons on the M40 Front Panel or M40 Remote to select that
source. The selected source will appear in the Front Panel
Display as shown in Diagram 27. If the M40 is in Standby a
press of one of these buttons will turn the M40 ON and select
the source.

Operating the Tuner

In Standby or with the M40 power ON, press the AM or FM
button on the M40 Front Panel or M40 Remote to select the
desired tuner band. The selected band and frequency of the
last tuned channel will appear in the Front Panel Display as
shown in Diagram 28. If the channel is FM Stereo, the STEREO
icon will appear. If the channel is a Preset, the Preset Number
will be displayed. If the M40 is in Standby a press of one of
these buttons will turn the M40 ON and select the Tuner Band.
Tuning (Manual)
With either the AM or FM Tuner selected, press the
TUNING or TUNING
TUNE or TUNE button or Left/Right Cursor buttons on
the M40 Remote to decrease or increase the tuner frequency
by one increment. When a tunable signal is received, the
TUNED icon will appear in the Front Panel Display over the
Band Indicator (AM/FM). If tuning FM, the STEREO icon will
appear in red to indicate a stereo signal. If the tuned frequency
is also a Preset, the Preset Number is indicated on the Front
Panel Display to the right of the tuned frequency.
Band
Press this button on the M40 Remote to toggle between the
AM and FM Bands.
FM Mode
Press this button on the M40 Front Panel or Remote to switch
the FM Tuner between stereo and mono modes. Typically, FM
Mode should be left in the stereo mode. The mono setting can
be useful for cleaning up background noise when tuned to
weak stereo channels.
button on the M40 Front Panel,
OPERATING THE M40
SP. A
M40 Front Panel
Diagram 27 Selecting a Source
TUNED STEREO
SP. A
Diagram 28 Tuner Controls
27
M40 Remote
MHz
M40 Front Panel
M40 Remote
PRESET CH.