Presets - Proficient Audio Systems M40 User Manual

OPERATING THE M40

Presets

The M40 can store up to 30 AM or FM Preset Channels (30 total). They can be stored manually by individually tuning channels and
saving them as Presets. The Auto Preset function can be used to quickly store up to 30 FM channels. Auto Preset will scan the FM
Band up to two times and then stop automatically.
Preset Programming (Manual)
1. Using the
TUNING or TUNING
M40 Front Panel or the
the M40 Remote, manually tune an AM or FM Channel
to be stored as a Preset.
2. Press the Memory button on the M40 Remote. MEMO will begin to flash slowly on the Front Panel Display.
(Diagram 29)
3. Enter a number from 1-30 to store the channel as a Preset.
Note: If a Preset has already been programmed entering that Preset Number with a new channel will replace the existing
Preset Channel.
Auto Preset
1. With the FM Tuner Band selected, press and hold the Auto Preset button on the M40 Remote until MEMO and Preset Number
begin to flash in the Front Panel Display. (Diagram 29) The M40 Tuner will scan the FM Band, and automatically store up to
30 tunable FM channels. If fewer than 30 channels are found, the tuner will scan the band two times and then stop.
Note: Once programmed, there may be channels that have been stored using Auto Preset that may be undesirable. These
channels can be replaced with AM channels or possibly some harder to tune FM channels that were not picked up in the
scan mode using the Preset Programming method in the previous section.
Tuning Preset Channels
Preset Channels can be tuned in three ways: Preset Scan, Manual Preset Tuning, Direct Numeric Preset Tuning.
Preset Scan
With the M40 ON and the Tuner selected, press the Preset
Scan button on either the M40 Front Panel or the M40
Remote to start a cycle through the programmed Preset
Channels. Each Preset will play for five seconds and then the
M40 will advance to the next Preset. Press the Preset Scan
button again to select a Preset Channel. The selected Preset
Number is indicated on the Front Panel Display to the right
of the tuned frequency.
Manual Preset Tuning
With either the AM or FM Tuner selected, press the
PRESET or PRESET
M40 Remote to select the previous/next programmed Tuner
Preset. The selected Preset Number is indicated on the Front
Panel Display to the right of the tuned frequency. The M40
Remote UP/DOWN Cursor buttons can also be used for this
function.
Direct Numeric Preset Tuning
With either the AM or FM Tuner selected, on the M40
Remote, press the Numeric buttons to select Preset
Channels. To select Preset 1, simply press 1. To select Preset
30, press 3-0.
buttons on the
TUNE or TUNE buttons on
button on the M40 Front Panel or
TUNED STEREO
SP. A B
Diagram 29 Programming Presets
TUNED STEREO
SP. A
Diagram 30 Tuner Preset Controls
28
MHz
MHz
M40 Front Panel
M40 Remote
MEMO
PRESET CH.
PRESET CH.