Edimax HP-5202Wn User Manual page 33

Click the "Start PBC" button to activate WPS – do not push the
WPS/Reset button on the extender.
PIN code setup varies slightly in that it requires you to manually enter a PIN
code into each device via the WPS Settings before activating WPS.
WPS Status
Device PIN Code
SSID
Authentication Mode
Passphrase Key
Config Mode
Configure via Push
Button
Input Client PIN Code
The WPS LED (
active for two minutes. Within two minutes, activate WPS on your client
device (refer to client device's user manual for guidance on how to do so) in
order to establish a connection. The WPS LED (
successful connection, and will remain ON for 5 minutes (see
Displays "Configured" or "unConfigured" depending
on whether WPS Settings for the extender have been
configured or not, either manually or using the WPS
button.
This is the WPS PIN code of the wireless extender for
use with other WPS-enabled wireless devices.
Displays the current SSID (the name used to identify
the wireless extender).
Displays the current wireless security/encryption type.
Shows the WPA passphrase here, though all characters
will be replaced by asterisks for security reasons. If
encryption is not set on the access point, this field will
be blank.
The configuration mode of the extender's WPS setting
is displayed here. "Registrar" means the device acts as
an access point for a wireless client to connect to and
the wireless client(s) will follow the extender's
wireless settings. "Enrollee" means the device acts a
wireless client and will follow the settings of the
wireless router/access point.
Click "Start PBC" to activate WPS on the extender.
Input the wireless client's PIN code here and click
"Start PIN" to activate PIN code WPS. Refer to your
wireless client's documentation if you are unsure of its
PIN code.
) will flash slowly to indicate WPS is active. WPS will remain
) will display ON to indicate a
33
I-3. LED Status).