To Change Volume Lock To Aux Mode; Troubleshooting - COX universal remote control User Manual

Cox Manual
3.
4.

To change Volume Lock to AUX mode:

NOTE: Performing these steps will allow you to access the volume
control of your auxiliary device in all modes.
1.
2.
3.
4.

TROUBLESHOOTING

PROBLEM:
SOLUTION: Replace the batteries with two (2) new AA
PROBLEM:
SOLUTION: Make sure you are aiming the remote control at
PROBLEM:
SOLUTION: Try all listed codes for the device brand being set
PROBLEM:
SOLUTION: Use the VCR codes for your brand. Some combo
PROBLEM:
SOLUTION: Follow instructions in Changing Volume Lock
11/27/01
Press VCR once. It will blink twice.
Now, whenever you press VOL+, VOL-, or
MUTE, volume will be controlled by your VCR.
On the remote control, press AUX once.
Then press and hold SETUP until the
AUX key blinks twice, then release SETUP.
Enter 9 - 9 - 3. The AUX key will blink twice.
Press AUX once. It will blink twice.
Now, whenever you press VOL+, VOL-, or MUTE,
the volume will be controlled by your
auxiliary device.
Mode key does not blink when you press a key.
alkaline batteries (see page 7).
Mode key blinks when you press a key, but home
entertainment device does not respond.
your home entertainment device and that you
are within 15 feet of the device you are trying
to control.
The remote control does not control home enter-
tainment devices or commands are not perform-
ing properly.
up. Make sure all devices can be operated with
an infrared remote control.
TV/VCR combo does not respond properly.
units may require both a TV code and a VCR
code for full operation (see page 9).
No volume on a second TV.
(see previous page).
7:14 PM Page 27
continued on the next page...
27