Re-Assigning Device Keys - COX universal remote control User Manual

Cox Manual

RE-ASSIGNING DEVICE KEYS

The Cox Universal Remote Control can be set up to con-
trol a second TV or VCR, or any combination of up to
four home entertainment devices. For example, to have
the unit control a TV, a Cable Converter, and two VCRs,
you will need to re-assign the unused AUX key to oper-
ate the second VCR as follows:
1.
2.
3.
4.
To re-assign other device keys, repeat steps 1 to 4 and
substitute the key sequence using the following chart:
To Re-Assign
TV as 2nd VCR key:
TV as 2nd Auxiliary key: SETUP - 9 - 9 - 2 - AUX - TV
TV as 2nd Cable key:
TV back to TV:
VCR as 2nd TV key:
VCR as 2nd Auxiliary key: SETUP - 9 - 9 - 2 - AUX - VCR
VCR as 2nd Cable key:
VCR back to VCR:
AUX as 2nd TV key:
AUX as 2nd VCR key:
AUX as 2nd Cable key:
AUX back to AUX:
Upon completion of a re-assignment, the selected mode
key will blink twice to confirm your selection. Then, you'll
need to program device control (see Programming Device
Control on page 8).
11/27/01
On the remote control, press VCR once.
Then press and hold SETUP until the VCR key
blinks twice, then release SETUP.
Enter 9 - 9 - 2. The VCR key will blink twice.
Press VCR once, then press AUX once. The
VCR key will blink twice.
The AUX key is now ready to be programmed
for your second VCR. See Programming Device
Control on page 8.
7:14 PM Page 25
Perform Key Sequence
SETUP - 9 - 9 - 2 - VCR - TV
SETUP - 9 - 9 - 2 - CABLE - TV
SETUP - 9 - 9 - 2 - TV - TV
SETUP - 9 - 9 - 2 - TV - VCR
SETUP - 9 - 9 - 2 - CABLE - VCR
SETUP - 9 - 9 - 2 - VCR - VCR
SETUP - 9 - 9 - 2 - TV - AUX
SETUP - 9 - 9 - 2 - VCR - AUX
SETUP - 9 - 9 - 2 - CABLE - AUX
SETUP - 9 - 9 - 2 - AUX - AUX
25