Electrical Safety - Wel-Bilt 24288 User Manual

• Keep children and bystanders away while operating a power tool. Distractions can cause you
to lose control, so visitors should remain at a safe distance from the work area.
• Be aware of all power lines, electrical circuits, water pipes and other mechanical haz-ards in
your work area, particularly those hazards below the work surface hidden from the operator's view
that may be unintentionally contacted and may cause personal harm or property damage.
• Be alert of your surroundings. Using power tools in confined work areas may put you
dangerously close to cutting tools and rotating parts.

ELECTRICAL SAFETY

WARNING!
Always check to ensure the power supply corresponds to the voltage on the plate.
• Do not abuse the cord. Never carry a portable tool by its power cord, or yank tool or extension
cords from the receptacle. Keep power and extension cords away from heat, oil, sharp edges or
moving parts. Replace damaged cords immediately. Damaged cords may cause a fire and increase
the risk of electric shock.
• Grounded tools must be plugged into an outlet properly installed and grounded in accor-dance
with all codes and ordinances. Never remove the grounding prong or modify the plug in any way. Do
not use any adapter plugs. Check with a qualified electrician if you are in doubt as to whether the
outlet is properly grounded.
• Double insulated tools are equipped with a polarized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still doesn't fit, contact a qualified electrician to install a polar-ized outlet. Do not change
the plug in any way.
• Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and refrig-erators.
There is an increase risk of electric shock if your body is grounded.
• When operating a power tool outside, use an outdoor extension cord marked "W-A" or "W."
These cords are rated for outdoor use and reduce the risk of electric shock.
• Extension Cord Use:
A. Use only 'Listed' extension cords. If used outdoors, they must be marked "For Outdoor Use."
Those cords having 3-prong grounding type plugs and mating receptacles are to be used with
grounded tools.
B. Replace damaged or worn cords immediately.
C. Check the name plate rating of your tool. Use of improper size or gauge of extension cord may
cause unsafe or inefficient operation of your tool. Be sure your extension cord is rated to allow
sufficient current flow to the motor. For the proper wire gauge for your tool, see chart.
CHART FOR MINIMUM WIRE SIZE OF EXTENSION CORD:
If in doubt, use larger cord. Be sure to check voltage requirements of the tool to your incoming
power source.
Page of 13 3