Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Wel-Bilt 1433781
Summary of Contents for Wel-Bilt 1433781
- Page 1 10-Pc. Multi-Purpose Angle Ginder Set OWNER'S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item # 1433781...
-
Page 2: Intended Use
Thank you very much for choosing a Wel-Bilt product! For future reference, please complete the owner's record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. -
Page 3: General Safety Rules
GENERAL SAFETY RULES WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. WARNING! The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. -
Page 4: Personal Safety
• Extension Cord Use: A. Use only 'Listed' extension cords. If used outdoors, they must be marked “For Outdoor Use.” Those cords having 3-prong grounding type plugs and mating receptacles are to be used with grounded tools. B. Replace damaged or worn cords immediately. C. - Page 5 • Remove adjusting keys or wrenches before connecting to the power supply or turning on the tool. A wrench or key that is left attached to a rotating part of the tool may result in personal injury. • Always inspect the grinder before use and have any damage repaired by an authorized service agent.
- Page 6 ASSEMBLY Be sure to disconnect the angle grinder from the power supply before attaching or removing the disc or attachment. Make sure that a grinding or cutting disc is mounted with the label on top or facing the angle grinder. If you are fitting any other kind of attachment, refer to attachment fitting instructions.
- Page 7 Guard Replacement See Figure 1. After extended use, the guard may become worn and need adjustment or to be replaced. Or if you drop the angle grinder and damage the guard, it may be necessary to replace it. To replace the guard: 1.
-
Page 8: Maintenance
4. Hold the brush cap with the carbon brush and slightly insert into the brush tube. Make sure curvature of brush matches curvature of motor and that brush moves freely in brush tube. 5. Replace brush cap and tighten securely. Do not overtighten. MAINTENANCE WARNING: Make sure this tool is disconnected from its power source before attempting any maintenance, cleaning, or inspection. -
Page 9: Troubleshooting Guide
TROUBLE SHOOTING GUIDE Be sure to follow safety rules and instructions PROBLEM POSSIBLE CAUSE REMEDY Unit will not operate No supply Check that supply is available at power outlet Switch is faulty Service agent repair Motor components Service agent repair open or short circuited Unusual sound or runs Mechanical obstruction Service agent repair... -
Page 10: Diagram & Parts List
DIAGRAM & PARTS LIST No. Description Qty. No. Description Qty. Clamp nut 29 Armature Wheel disc 30 Ball bearing 607-2Z Flange 31 Bearing cover Wheel guard 32 Windfield Screw M5 20 33 Stator Output shaft 34 Stator case Screw M4 12 35 Pusher rod Key 3 10 36 Pusher... - Page 12 WARNING Some dust created by power sanding, sawing, grinding, drilling,and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, •...