Transporting The Ups - HP R3000v User Manual

UPS MAINTENANCE

Transporting the UPS

26
HP R3000v UPS User Guide
NOTE: The UPS internal batteries MUST be disconnected during transport.
If the UPS requires any type of transportation:
1. Verify that the UPS is unplugged and turned off.
2. Remove the UPS right front bezel. See Figure 18.
To remove the bezel, loosen the two captive screws on the right side of the bezel.
Grasp the top and bottom of the bezel and slide the bezel to the right.
NOTE: A ribbon cable connects the control panel to the UPS. Do not pull on the cable or
disconnect it.
3. Disconnect the internal battery connector (see Figure 19).
4. Replace the UPS front bezel.
S 164201731 Rev 1
NOTE: Leave
ribbon cable
connected.
Figure 18 Removing the UPS Right Front Bezel
Figure 19 Disconnecting the UPS Internal Batteries