Table of Contents
Advertisement
2. Hardware Installation
Installing Two Stand Alone Fiber Converters Together
1. Connect an RJ-45 Ethernet cable from the Ethernet port on the fiber converters to an Ethernet
port on your switch (e.g TE100-S24g).
2. Connect the fiber cable to the fiber converters.
3. Connect the power adapter to the fiber converter.
Note:
For the TFC-110MM/MST/MSC/110S15/S15i/S30/S30i/S60/S60i/S100, the TX and RX cables
must be reversed on the opposite fiber connection
TFC-15MS100 converts Multi-Mode to Single-Mode fiber, it can be connected to a switch with
Multi-Mode SC-type fiber connection (e.g TEG-424WS with fiber modules) to extend the distance
up to 15km with Single-Mode fiber.
Cabling
• Multi-Mode Fiber Optic Cable: TFC-110MSC, TFC-110MST, TFC-110MM
• Single-Mode Fiber Optic Cable: TFC-110S15, TFC-110S30, TFC-110S60, TFC-110S100,
TFC-110S15i, TFC-110S30i, TFC-110S60i
• Single Strand Fiber Optic Cable: TFC-110S20D3i, TFC-110S20D5i, TFC-110S40D3,
TFC-110S40D5, TFC-110S40D3i, TFC-110S40D5i
2
Advertisement
Table of Contents
