Hardware Installation - TRENDnet TFC-110MM Quick Installation Manual

2. Hardware Installation

Installing two stand alone Fiber Converters
1. Connect the fiber cable to the fiber
converters. This cable must be
multi-mode for the TFC-110MM/
MST/MSC. This cable must be
single-mode for the
TFC-110S15/S30/S60/S100/
S20D3/S20D5/S40D3/S40D5.
2. Connect an RJ-45 Ethernet cable
from the Ethernet port on the fiber
converters to an Ethernet port on
your switch (e.g TEG-424WS).
3. Connect the power adapter to the
back of the fiber converter.
Note: The TX and RX cables must be reverse on the opposite fiber connection.
Note: The TFC-110S20D3 must be paired with the TFC-110S20D5. The
TFC-110S40D3 must be paired with the TFC-110S40D5.
Note: TFC-15MS100 converts Multi-Mode to Single-Mode fiber, it can be
connected to a switch with Multi-Mode SC-type fiber connection
(e.g TEG-S3000i with fiber modules) to extend the distance up to 15km with
Single-Mode fiber.
2
English