Table of Contents
Advertisement
Switch
Action
On
1
Off
On
2
Off
On
3
Off
On
4
Off
On
5
Off
On
6
Off
Note:
After changing the DIP Switch settings, power cycle the Fiber Converter.
LLCF stands for Link Loss Carry Forward. When LLCF is enabled, the ports do not transmit a link
signal until they receive a link signal from the opposite port. Link loss is "carried forward" to the
managed switch or hub that is sending the link. LLCF can be used for either the copper or fiber
ports.
LLR stands for Link Loss Return. When LLR is enabled, the fiber port's transmitter shuts down if
its receiver fails to detect a valid receive link. If one of the optical conductors is bad, the card with
LLR enabled will return a no link condition to its link partner. LLR is used to detect link problems
only on the fiber port. If LLR is enabled on one Fiber converter, the opposite Fiber converter must
have LLR disabled.
Function
TFC-110MM/MST/MSC/
110S15/S30/S60/S100
Half-Duplex
Full-Duplex
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
5
TFC-110S15i/30i/60i/20D3i/20D5i/40D3i/40D5i
Fiber Half-Duplex
Fiber Full-Duplex
TX Forced Mode
TX Auto-Negotiation
TX 10M
TX 100M
TX Half-Duplex
TX Full Duplex
LLR Enable
LLR Disable
LLR Enable
LLR Disable
Advertisement
Table of Contents
