Accessories; Duty Cycle; Assembly; Assemble Handle - Craftsman 919.167631 Owner's Manual

This unit is capable of powering the following Accessories. The accessories are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.

Accessories

• In Line Filter
• Tire Air Chuck
• Quick Connector Sets (various
sizes)
• Air Pressure Regulators
• Oil Fog Lubricators
• Air Hose: 1/4" (6.4 mm), 3/8"
(9.5 mm) or 1/2" (12.7 mm) I.D. in
various lengths
This air compressor pump is capable
of running continuously. However, to
prolong the life of your air compressor,
it is recommended that a 50%-75%
average duty cycle be maintained; that
CONTENTS OF CARTON
1 - Air Compressor
1 - Handle
1 - Grip Handle
4 - Self Tapping Screw
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
1 - Rubber Strip
TOOLS REQUIRED FOR

ASSEMBLY

2 - 9/16" open end wrenches
1 - 3/8" socket
UNPACKING
Remove unit from carton and discard
all packaging. NOTE: Save all parts
bags.

ASSEMBLE HANDLE

1. To make installation easier, sub-
merge handle grip into warm
soapy water. Remove handle grip
from soapy water and slide onto
handle.
2. Insert the handle inside the com-
pressor saddle and line up the
two bolt holes on each side.
ACCeSSOrieS
Refer to the selection chart located on
the unit to select the tools this unit is
capable of powering.
not recommended for use with
this tool could be hazardous. Use
only accessories rated equal to
or higher than the rating of the air
compressor.

DUTY CYCLE

is, the air compressor pump should
not run more than 30-45 minutes in
any given hour.
ASSEMBLY
Handle
Grip
3.
4.
ASSeMBLe WHeeLS
one side of the unit when installing
the wheels because the compressor
will have a tendency to tip.
1.
10- ENG
The use of any
other accessory
Handle
Rubber Strip
Install the four screws, two on
each side.
Tighten securely.
it will be necessary
to brace or support
Attach wheels with shoulder bolts
and nuts as shown.
Screw
Nut
Shoulder
Bolt
Wheel