Advertisement
Available languages
Available languages
Customer
Responsibilities
Before
Daily or
each
after
each
use
use
3heck Safety Valve
•
3rain Tank
•
Risk of Unsafe
TO
Operation. Unit
1.
cycles automatically
when power is
on. When servicing, you may be
exposed to voltage sources,
2.
compressed
air, or moving parts.
Before servicing unit unplug or
disconnect electrical supply to the
air compressor, bleed tank of
3.
pressure, and allow the air
compressor to cool.
4.
NOTE: See "Operation"
section for
the location of controls.
To Check
Safety
Valve
Risk of Bursting. If
the safety valve
does not work properly, over-
pressurization
may occur, causing
air tank rupture or an explosion.
1.
Before starting compressor,
pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the valve is
stuck or does not operate
smoothly, it must be replaced
with the same type of valve.
5.
Drain Tank
Set the On/Auto/Off
lever to
"OFF" and unplug unit.
Pull the regulator knob out and
turn counterclockwise
to set the
outlet pressure to zero.
Remove the air tool or
accessory.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately
20 psi. Release safety valve ring.
Drain water from
air tank by
opening drain
valve on bottom of
Open Drain
tank.
Valve
Risk of Bursting.
Water will
condense in the air tank. If not
drained, water will corrode and
weaken the air tank causing a risk
of air tank rupture.
6.
After the water has
been drained,
close the drain
valve. The air
compressor can
Closed Drain
now be stored.
Valve
NOTE: If drain valve is plugged,
release all air pressure.
The valve
can then be removed, cleaned, the
reinstalled.
15_ ENG
A02265
Advertisement
