Plug In Refrigerator; Install Side Trims; Move Refrigerator To Final Location - Jenn-Air W10379136B Installation Manual

Plug in Refrigerator

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Set control switch at top of cabinet to the OFF position.
2. Plug into a grounded 3 prong outlet.

Install Side Trims

The side trims cover the space between the refrigerator and the
adjacent cabinets. There is a trim piece taped to each side of the
refrigerator. Install each trim piece to the side of the refrigerator to
which it is taped.
1. Remove the tape attaching the trim pieces to the sides of the
refrigerator. Set the trim pieces aside.
IMPORTANT: For installations using custom wood panels
with " gap, the bulb-shaped section of the trim piece will
interfere with the panels. Score each trim piece at the base of
the bulb-shaped section, then remove and discard this
section. See the "Top View" graphic later in this section.
2. Remove the 4 screws from the side of the refrigerator cabinet.
A
A. Side trim screws
3. Using the original holes and the screws removed in Step 2,
fasten the side trim to the refrigerator cabinet.
NOTE: Make sure to fasten each trim piece to the side of the
refrigerator cabinet from which it was removed. The bulb-
shaped section should be forward with the notch at the top,
as shown.
Top View
C
D
A. Side trim
B. Adjacent cabinet

Move Refrigerator to Final Location

WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
To avoid floor damage, make sure levelers are raised (not
touching floor) and refrigerator is on rollers before moving.
Use the installation block, attached to the door hinge, as a
reference to make sure the refrigerator is pushed back far
enough into the opening, so that when the panels are
installed they will be flush with the adjacent cabinets.
NOTE: A flush installation is not possible with a 24" (60.9 cm)
deep opening.
A
B
C. Door
D. Bulb-shaped section
17