Table of Contents
Advertisement
Available languages
Available languages
Standard Grille Installation—Flush Grille—Open or Closed
Soffit
1" (2.54 cm)
5 "
(14.55 cm)
Unpack the Refrigerator
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
Do not remove the film covering until the refrigerator is in its
operating location.
All four leveling legs must contact the floor to support and
stabilize the full weight of the refrigerator.
Keep the cardboard shipping piece or plywood under the
refrigerator until it is installed in the operating location.
1. Remove and save the literature package and hardware kit
located inside the refrigerator. Remove and save the
literature, grille, and trim taped to the outside of the
refrigerator.
NOTE: Do not remove tape and door bracing until the
refrigerator is in its final location.
14
D
Top Grille Filler
E
Top Grille Panel
INSTALLATION INSTRUCTIONS
Model
42
Reveal
"
"
D
41 "
41 "
(104.78 cm)
(106.05 cm)
E
41 "
41 "
(104.78 cm)
(106.05 cm)
IMPORTANT: The grille panel height, shown in the "Standard
Integrated Grille Installation—Side View" graphic, allows for an air
gap critical to refrigerator performance.
Move the Refrigerator into House
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
1. Place an appliance dolly under the left side of the refrigerator
as shown. Place the corner posts from the packing materials
over the trims as appropriate. Slowly tighten the strap.
2. Place pieces of the shipping carton on the floor when rolling
the dolly and refrigerator into the house. Move the refrigerator
close to the built-in opening.
3. Place top of cardboard carton or plywood under refrigerator.
4. Stand the refrigerator up. First, place the left bottom edge of
the refrigerator on the floor, stand the refrigerator upright and
then lower the right-hand side of the refrigerator to the floor.
5. Reassemble the trim and top grille after the dolly has been
removed from the refrigerator.
48
"
"
47 "
47 "
(120.02 cm)
(121.29 cm)
47 "
47 "
(120.02 cm)
(121.29 cm)
Advertisement
Table of Contents
