S Can P Rogramming - Kenwood TK-5710 Series Instruction Manual

S p
cAn rogrAMMing
Note: Scan programming is only available when using Conventional operation.
■ Conventional Operation
If Scan Type has been programmed for Conventional operation, you are able
to reprogram your scan list.
1 Press the key programmed as Scan Program.
• The
2 Press the GRP
and channel you will add to or remove from the Scan list.
• Press the PF 2 key to toggle between Zone Select and Channel Select.
3 Press the PF 4 key to add or remove the selected zone or channel to/ from
the scan list.
• The zone add indicator (KCH-4:
channel add indicator (KCH-4:
appear on the display when the selected channel is added to the scan sequence.
4 Press the PF 1 key to exit scan programming.
If the Priority channel has been set as Operator Selectable by your dealer, you
are able to reprogram the Priority mode as well.
1 Press the key programmed as Scan Program.
• The
2 Press and hold the PF 3 key to edit the Priority channel.
3 Press the GRP
channel you will set or unset as Priority.
4 Press the PF 4 key to toggle the selected channel between Priority and
Normal.
• "P", "P2", or "PP" appears on the sub-display when Priority mode is selected.
5 Press the PF 3 key again to set the new channel setting.
6 Press the PF 1 key to exit scan programming.
(KCH-4 ) or
SCAN
and keys or rotate the CH control to select the zone
(KCH-4) or
SCAN
and keys or rotate the CH control to select the
(KCH-5) icon appears on the display and blinks.
(KCH-5) icon appears on the display and blinks.
/ KCH-5:
/ KCH-5:
)/
) will
7