S Electing A Z One And C Hannel; T Ransmitting - Kenwood TK-5710 Series Instruction Manual

S Z
elecTing A one And
Select the desired zone using the GRP
group of channels.
Select the desired channel using the CH control. Each channel is programmed
with settings for transmitting and receiving.
• If programmed by your dealer, the transceiver will announce the zone and channel
numbers as you change them.
Names can be programmed for zones and personalities. Your dealer can set the
zone name to a length of 0 to 4 digits. To fit on the display, personality names
will shorten appropriately. (KCH-4 models display only 2 digits). For example,
if the channel name is "–CHANNEL–" and the zone name is "KENWOOD", and
your dealer sets the zone name to 4-digits, the following display will appear:
KCH-4 (2-digit display):
KCH-5 (4-digit display):
T
rAnSMiTTing
For Trunking channels, refer to "Making Group Calls" and "Making Individual
Calls" on the following page.
1 Select the desired zone and channel using the GRP
CH control.
2 Press (or press and hold) the key programmed as Monitor to check whether
or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the microphone PTT switch and speak into the microphone. Release
the PTT switch to receive.
• The TX indicator lights red while transmitting. The BUSY indicator lights green while
receiving a signal. This indicator can be disabled by your dealer.
• For best sound quality at the receiving station, hold the microphone approximately
.5 inches (3 ~ 4 cm) from your mouth.
2
c
hAnnel
KENW–CHANNEL
KENW–CHANNEL–
and keys. Each zone contains a
and keys and the