Disassembly Tools - Lexmark MS610dn Manual

Printed circuit boards greater than 10 cm
Toner cartridges, liquid and pasty, as well as colour
toner
Plastic containing brominated flame retardants
Asbestos waste and components which contain
asbestos
Cathode ray tubes
Chlorofluorocarbons (CFC), Hydrochlorofluorocarbons
(HCFC) or Hydrofluorocarbons (HFC), Hydrocarbons
(HC)
Gas discharge lamps
Liquid Crystal Display (LCD) greater than 100 cm
those back-lighted with Gas discharge lamps
External electrical cables
Components containing refractory fibres
Components containing radioactive substances
Electrolyte capacitors containing substances of
1
concern
1
With (height > 25 mm, diameter > 25 mm or proportionately similar volume)

3. Disassembly tools

Item
#2 Phillips screwdriver, magnetic
Wire cutter
E-clip puller or small flat-head screwdriver
Standard slotted head screwdriver
Disassembly references
4.
4.1. Removal procedure(s)
MS310 WEEE removal
WEEE materials and components removal procedures are available upon request.
Contact: recycling@lexmark.com
Doc No.:
4
2
1
1 Fan;
12
Sensors;
3 Fuser
parts
0
0
0
0
2
and 0
1
0
0
1
MS410 WEEE removal
Rev. 001
Plus one (1) for MS610dtn and
MS610dte models (locations illustrated
in 4.2)
Located inside front cover
Fan(s) and Sensors (locations
illustrated in 4.2)
Plastic parts located in the
fuser assembly marked with
recycle code that includes "FR17"
(See Appendix A for description)
N/A
N/A
N/A
N/A
N/A
Power cord located on the back lower
left quadrant
N/A
N/A
Capacitor(s) located on Power Supply
(locations illustrated in 4.2)
MS510 & MS510 WEEE removal
Page 2 of 13