Tools And Supplies - Lexmark Optra M410 Remanufacturing Instructions

Lexmark Optra M410/M412, Remanufacturing Instructions
® ®
Tools and Supplies You Will Need
Use of Compressed Air
As of April 28, 1971, the Occupational Safety & Health
Administration (OSHA) Standard, 29 CFR 1910.242 paragraphs a
& b for general industry requires effective chip guarding and
personal protective equipment (PPE) when using compressed
air. When cleaning residual toner particles from cartridges
using a compressed air system, you must use air nozzles
meeting OSHA requirements. Air nozzles that regulate air
pressure to a maximum of 30 psi comply with this standard.
Refer to the OSHA publication for any updates or changes that
have occurred since the date noted above.
Use of Isopropyl Alcohol
For best results, we recommend using ONLY 91-99% for cleaning
as directed in these instructions. 91% isopropyl alcohol is
available at most major drug stores; 99% isopropyl alcohol is
available through distributors of chemical products. Follow the
alcohol manufacturer's safety instructions.
Separation of the Cartridge
NOTE
There is no shutter on the Optra
OPC. If you plan to reuse the drum, wear gloves or use other
aids to prevent touching the drum with your bare hands, and
use extreme care not to damage the OPC while separating
the cartridge.
1.
Prepare to separate the cartridge
Remove any OEM warranty labels from over the hopper cap
(FIG 1a) and between the hopper and waste bin sections (FIG 1b)
before proceeding.
page 2 SSS.314
M to protect the
®
Remove
OEM
warranty
label from
hopper cap
FIG 1a

Tools and Supplies

Recommended for Basic Remanufacturing:
• Phillips Screwdriver
• Small Flat-Blade Screwdriver
• Needle Nose Pliers
• Hook Tool . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .HTOOL
• Conductive Cartridge Lubricant . . . . . . . . . . . . . .CONCLUBE
• Compressed Air for Cleaning . . . . . . . . . . . . . . . . . . .(See left)
• 91-99% Isopropyl Alcohol . . . . . . . . . . . . . . . . . . . . . . .(See left)
• Lint-free Foam Tip Swab . . . . . . . . . . . . . . . . . . . . . . . .LFSWAB
• Cotton Swab . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .QTIP
• Kynar ® Lubricating Powder . . . . . . . . . . . . . . . . . . . . . . .KPOW
• Toner qualified for Optra M410/M412
®
• Lexmark ® Optra ® M410/M412 Printer
Remove OEM warranty
label from hopper and
waste bin sections
Optra
M412
Optra
M410
FIG 1b