Dell C2665dnf Manual page 9

User Information Per Blue Angel Mark Requirements of RAL-UZ171
Energy data
Information on the Device Dell™ C2665dnf Color Laser Multifunction
Printer
Electric
power
consumption
of a device
depends both
on its
characteristics
and on the
way you use
it. Your
device is
designed and
pre-set so
that you can
save
electricity costs. It switches over to the mode "ready" after the last copy. From
there, the device can immediately start printing again if required. If not
required, the device switches over to electric power saving modes in two steps
after a certain time, which is called activation time. In these modes, it
consumes less power (watt). The device will take some more time to print
again from an electric power saving mode than from the mode "ready". This
delay is called return time, which is quite long for some devices. The device
Dell™ C2665dnf Color Laser Multifucntion Printer, however, fulfills the strict
Blue Angel requirements for the return time (http://www.blauer-engel.de). It
only takes 13 seconds, for example, to return from Energy saving mode 2 to
ready mode for printing. This is only a short moment for you but will help you
to save electricity and hence operating costs if the device is pausing (hence,
during no-load operation).
The device is so designed in such a way that switching it on and off up to
twice a day to the plug-in off mode will not cause damage.
Power consumption and default times
of Dell C2665dnf Color Laser Multifunction Printer
during time elapsed after last print
Ready mode (67W)
60
50
40
print mode
30
20
10
0
Ti m e e l a p s e d a f t e r l a s t p r i n t i n g = i d l e m o d e [ m i n u t e s ]
Energy saving mode 1 (15.0W)
10
Energy saving mode 2 (3.5W)
30 time (min.)