Loading Discs - Toshiba DX1210 series User Manual

Loading discs

To load a disc, follow the steps as detailed below:
1. When the computer's power is on, press the eject button to open
the disc tray slightly.
2. Grasp the disc tray gently and pull until it is fully opened.
1. Eject button
3. Lay the disc, label side up, in the disc tray.
1. Laser lens
When the disc tray is fully opened, the edge of the computer will extend
slightly over the disc tray. Therefore, you will need to turn the disc at an
angle when you place it in the disc tray. After seating the disc, however,
make sure it lies flat.
User's Manual
Figure 4-2 Pressing the eject button and pulling the disc tray open
Figure 4-3 Inserting a disc
1
2
2. Disc tray
Operating Basics
1
4-7