Before Using Your Multiblender Pro & Multiblender Platinum - Sunbeam PB7620 MultiBlender Pro Instruction/Recipe Booklet

Before using your MultiBlender
Pro & MultiBlender
Important: Always ensure your blender is
unplugged from the power outlet before
fitting or removing the blade assembly.
Always handle the blade assembly with
caution, as the blades are extremely sharp.
Before using your MultiBlender™ Pro or
MultiBlender™ Platinum, we recommend
removing the six-blade system for thorough
cleaning.
To remove the six blade system in the glass jug
Unscrew the blade system from the jug, using
the inner measuring cup from the lid and
turning anti-clockwise (refer Fig. 1). Remove
the silicone rubber seal from the blade
assembly. Wash the lid, jug, silicone rubber
seal and the blade assembly in warm soapy
water.
Note: When removing the blade assembly
from the jug you may need to slightly tilt the
blade so that it slides out easily.
To re-assemble the six-blade system in the glass
jug (refer Fig.2)
1.Place the silicone rubber seal
blade assembly, as shown opposite.
2.Position the blade assembly into the
base of the blender jug
the blade assembly is firmly in place by
turning it clockwise as indicated by the
arrow.
Note: Do not remove the stainless steel blades
from the blade assembly.
Note: The blender jug will leak if the
six-blade system is not assembled correctly.
over the
1
2
1
3
. Ensure that
2
3
Platinum
™
™
Figure 1
1
2
3
1
2
3
Figure 2
5