Convergent Design nanoFlash User Manual page 13

Record button – Recording is started by pressing the Record Button on the unit, and
stopped by pressing the Stop button.
Remote & Record button – Remote switch and Record button can be used to start / stop
Record. (ver1.5.126)
Power up – Recording is automatically started by applying power and video source, Record
is stopped by removing video source. Do not use in combination with Pre-Record Buffer
(System->PreBuffer), Crank, 720p60->30/50->25, 3:2 Pulldown Removal, or Time-
Lapse. (ver1.5.126)
Duration HH:MM:SS If enabled, each record session will last only for the specified
HH:MM:SS. (ver1.5.31)
Timecode
Sets the time-code source, and (for internally generated timecode only) the drop-frame flag
and the initial value (seed)
Source (Embedded, Internal, LTC)
Dropframe – [ ] enable (checked) if drop-frame time-code should be generated (only
valid for internal time-code generation and 59.94/29.97 frame rates)
Seed – initial value for internal time-code only:
1. Set 01:00:05:19 – Manually set the initial time code. (HH:MM:SS:FF)
2. Time of day – Use time of day time code, based on the System->Time setting.
3. Reset – set the initial time-code to 00:00:00:00.
Trigger Delay – Seconds to delay Recording when using "Timecode" or "TC > Last TC"
trigger (System->Trigger). (See discussion in Trigger section, above. ) (ver1.6.226)
Source: Selects the video input source – choose between SDI and HDMI.
Format: Format (erase) all inserted CF cards. Use with caution! Note: CF card Volume
names may be defined on a computer. If the 8
name are all numbers, they will be incremented automatically with every format of the CF card
on nanoFlash (to help indicate card usage and life).
Power Saving
Auto Sleep
If this feature is turned on, the nanoFlash will drop to low power mode after 1 minute of
inactivity if no SDI input is present. (This feature does not apply for HDMI input.)
When the unit is in low power mode, power consumption drops to 0.3 watts, and the lcd
screen is active with "Low power mode" message displayed.
In low power mode, any of the following events will bring the unit back to full power:
Upon wakeup, the nanoFlash is completely rebooted (5 to 7 seconds). (ver1.6.226)
Auto LCD Off
nanoFlash
1. Embedded – timecode is extracted from HD/SD-SDI stream from the source
2. Internal – timecode is generated internally in the nanoFlash
3. LTC – timecode from external LTC input
4. Jam Sync – to use: provide momentary timecode jam sync (via the LTC
input port) while unit is in idle mode with a valid video input source. If video
source is lost or nanoFlash is placed in Play mode, timecode must be re-
sync'ed after video source returns or nanoFlash returns to idle mode.
> SDI input resumes.
> Any of the keys on the keypad are pressed.
> A remote tally, if attached, is pressed.
th ,9 th ,10 th , and 11th characters of the Volume
13