Computer Interface; Overview - Shure DFR11EQ User Manual

COMPUTER INTERFACE

Overview

This section describes the Windows based computer interface software which allows
you to utilize the full features of the Shure DFR11EQ. By connecting the DFR11EQ to your
computer, you can access additional control features to customize the operating
characteristics of the feedback filters. The computer interface also allows access to the
built-in digital, 30-band,
equalization curves can be displayed in the frequency response graph for an accurate
display of either the feedback filter response, EQ response, or both combined.
Minimum Computer Requirements
The following are the minimum requirements to run the Shure DFR11EQ software.
One 486DX 33MHz IBM*-compatible computer (math coprocessor required)
2 MB hard drive space
4 MB RAM
Windows version 3.1x, or greater
1 available RS-232 serial (COM) port
One RS-232 cable to connect the COM port of the computer to the DB-9 connector of
the DFR11EQ
Connecting the DFR11EQ to a Computer via the RS-232 (COM) Port
Before connecting the DFR11EQ to the computer, determine whether the computer's
RS-232 (COM) port is 9-pin or 25-pin. Use the proper cable (purchased separately). For
RS-232 cable diagrams, see Appendix C. Cables and Connectors.
1. Connect the 9-pin plug (male) of the cable to the RS-232 port of the DFR11EQ.
2. Connect the other end of the cable to the RS-232 port of the computer.
1
/ -octave, constant-Q, graphic equalizer.
3
TO COMPUTER
RS-232 CONNECTOR
10
The resulting
TO DFR11EQ
RS-232 CONNECTOR
(9-PIN MALE)
Main Menu
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ