Configuring Inter-Vlan Routing; Viewing The Routing Table - Cisco CVR100W Administration Manual

Configuring Network
Configuring Routing
STEP 4
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Cisco CVR100W Wireless-N VPN Router Administration Guide
Enter Route Name
Destination LAN IP
Subnet Mask
Gateway
Interface
Click Save.

Configuring Inter-VLAN Routing

To configure inter-VLAN routing:
Choose Networking > Routing.
In the Inter-VLAN Routing area, check Enable to enable inter-VLAN routing.
Click Save.

Viewing the Routing Table

To show the routing table:
Choose Networking > Routing.
To view the IPv4 routing information on your network, click Show IPv4 Routing
Table in the Routing Table area.
To view the IPv6 routing information on your network, click Show IPv6 Routing
Table in the Routing Table area.
Enter the name of the route.
Enter the IP address of the destination LAN.
Enter the subnet mask of the destination network.
Enter the IP address of the gateway used for this route.
Select the interface to which packets for this route are
sent:
• LAN: Click this radio button to direct packets to
the LAN.
• WAN: Click this radio button to direct packets to
the Internet (WAN).
3
51