Rebooting The Cvr100W; Restoring The Factory Defaults - Cisco CVR100W Administration Manual

Administering Your CVR100W

Rebooting the CVR100W

STEP 5
Rebooting the CVR100W
STEP 1
STEP 2

Restoring the Factory Defaults

!
CAUTION
NOTE
Cisco CVR100W Wireless-N VPN Router Administration Guide
Go to the Status > System Summary page to make sure that the CVR100W is
using the new firmware version.
To reboot the CVR100W, you can press and release the RESET button on the back
panel for less than 5 seconds, or perform the Reboot operation from web-based
Configuration Utility.
To reboot the CVR100W from web-based Configuration Utility:
Choose Administration > Reboot.
Click Reboot.
Rebooting the device will close all current sessions and the system will be down
for several seconds.
To restore the CVR100W to the factory default settings, you can press and hold
the RESET button on the back panel for more than 5 seconds, or perform the
Reset to Factory Defaults operation from web-based Configuration Utility.
During a restore operation, do not try to go online, turn off the router, shut down the
PC, or use the router until the operation is complete. This should take about a
minute. When the test light turns off, wait a few more seconds before using the
router.
The Reset To Factory Defaults operation will wipe out the current settings used on
the CVR100W. We recommend that you back up your current settings before
restoring the CVR100W to the factory default settings.
8
132