Boiler Location; Dimensions & Minimum Clearances; Service Connections; Position - Keston 50 - GC Installation And Servicing Instructions

WD50/2/1997
2.1 DIMENSIONS AND MINIMUM
CLEARANCES
The boiler must be installed in
minimum clearances shown to allow
subsequent
operation.
2.2

SERVICE CONNECTIONS

Gas, water, air and flue pipe,
condensation, and electrical
connections are as shown. Gas : 0.5
inch BSP male. Flow/Return : 28 mm
copper.
2.3

POSITION

The Keston is not
suitable for external
installation. The boiler
may be installed in any
room or internal space,
although particular
attention is drawn to the
requirements of the
current IEE Wiring
Regulations and, in
Scotland, the electrical
provisions of the Building
Regulations applicable in
Scotland, with respect to
the installation of the
boiler in a room or
internal space containing
a bath or shower.
Where a room-sealed
appliance is installed in a
27
47
181
237
Top View
Installation & Servicing Instructions
Chapter 2 - Boiler Connections

2. BOILER LOCATION

servicing, and safe
Air Intake
Figure 2.1.2
Dimensions
405
Service Connection Locations
Page : 6
The Keston 50, 60 & 80 Condensing Boilers
All dimensions in mm.
1
305
Return
Flue
500
60
97
254
Figure 2.1.1
127
Minimum Clearances
Flow
All dimensions in mm.
All dimensions are in mm.
68
Base View
1
30
37