Monitor Protocol; Monitor Subscriber - Cisco ASR 5000 Administration Manual

▀ eWAG Administration

Monitor Protocol

The system's protocol monitor displays information for every session that is currently being processed. Depending on
the number of protocols monitored, and the number of sessions in progress, a significant amount of data is generated. It
is highly recommended that logging be enabled on your terminal client in order to capture all of the information that is
generated.
To view monitor protocol based logging information, in the Exec Mode use the following command:
monitor protocol
For eWAG use the following filters:
 41 - IPSG RADIUS Signal: Must be used to view the RADIUS accounting messages on the control path for
IPSG session management.
 24 - GTPC
 26 - GTPU

Monitor Subscriber

The system's protocol monitor can be used to display information for a specific subscriber session that is currently
being processed. Depending on the number of protocols monitored, and the number of sessions in progress, a significant
amount of data is generated. It is highly recommended that logging be enabled on your terminal client in order to
capture all of the information that is generated.
To view monitor subscriber based logging information, in the Exec Mode use the following command:
monitor subscriber
The following filters are available for monitor subscriber based logging in eWAG.
 By MSID/IMSI
 By IP Address
 By MSISDN
 Next-IPSG Call
 By Username
▄ Cisco ASR 5000 Enhanced Wireless Access Gateway Administration Guide
54
Enhanced Wireless Access Gateway Configuration
OL-28188-02