Configuring Session Recovery - Cisco ASR 5000 Administration Manual

▀ eWAG Configuration
Verifying your Configuration
To verify your Congestion Control configuration, in the Exec Mode issue the following command:
show congestion-control configuration
The output of this command displays information including whether or not Congestion Control is enabled/disabled,
Congestion Control threshold parameter settings, Congestion Control policy, and more.

Configuring Session Recovery

To enable Session Recovery, use the following configuration:
configure
require session recovery
end
Notes:
 For more information on the Session Recovery feature, refer to the Session Recovery chapter of the System
Administration Guide.
 A valid feature key is required for this configuration. This command enables/disables the feature to try to
perform hitless session recovery for all session types supported by the software release. After enabling session
recovery through this configuration, make sure that session recovery status is "ready".
▄ Cisco ASR 5000 Enhanced Wireless Access Gateway Administration Guide
52
Enhanced Wireless Access Gateway Configuration
OL-28188-02