Cisco ASR 5000 Administration Manual page 43

Enhanced Wireless Access Gateway Configuration
end
Notes:
 In the APN profile configuration,
service. It should be configured as NI+OI for proper DNS resolution. Also, note that eWAG does not support
subscriber profile.

<dictionary_name>
starent-vsa1
 In the RADIUS accounting parameter configurations, the
RADIUS accounting messages to the configured RADIUS accounting client if the call goes down due to any
failure. If this option is not configured, the eWAG will not send Disconnect-Message in call failure scenarios.
 In the binding configuration, the
accounting requests are received. This keyword should be configured if the source of the RADIUS requests is
in a different context than the eWAG service. If not configured, the system will default to the context in which
the eWAG service is configured.
Configuring eWAG + GGSN Combo Deployment
To configure the eWAG service for an eWAG + GGSN combo deployment use the following configuration:
configure
context <context_name>
ipsg-service <ipsg_service_name> mode radius-server ewag
#To associate an SGTP service:
associate sgtp-service <sgtp_service_name> [ context <sgtp_context_name> ]
#To bind the eWAG service to a logical AAA interface and configure the number of
subscriber sessions allowed:
bind address <ipv4/ipv6_address> [ max-subscribers <max_sessions> | port
<port_number> | source-context <source_context> ]
#To configure location-specific mobile network identifiers:
plmn id mcc <mcc_number> mnc <mnc_number>
#To enable APN profile for eWAG and optionally configure the default APN:
profile APN [ default-apn <apn_name> ]
#To configure QoS DSCP parameters:
ip { gnp-qos-dscp | qos-dscp } qci { { { 1 | 2 | 3 | 4 | 9 } | { 5 | 6 | 7 | 8 }
allocation-retention-priority { 1 | 2 | 3 } } { af11 | af12 | af13 | af21 | af22 | af23 |
af31 | af32 | af33 | af41 | af42 | af43 | be | ef | pt } } +
#To configure RADIUS dictionary:
radius dictionary <dictionary_name>
OL-28188-02
<default_apn_name>
specifies the RADIUS dictionary to use for the eWAG service. In this release, only the
dictionary is supported for eWAG. .
source-context
specifies the default APN to be used for the eWAG
disconnect-message
option specifies the source context where RADIUS
Cisco ASR 5000 Enhanced Wireless Access Gateway Administration Guide ▄
eWAG Configuration ▀
option enables sending
43