Connecting And Operating The Scanner; Preparing The Host Computer - Kodak HR 500 Operator's Manual

2

Connecting and Operating the Scanner

Preparing the Host Computer

August 2001
This chapter gives instructions for:
• preparing the host computer
• connecting the Kodak Professional HR 500 Film Scanner to the host
computer
• starting up the scanner system
• preparing to scan an image
• performing a scan
• shutting down the scanner
CAUTION: Do not connect power to the scanner.
1. Install the Ultra-Wide SCSI board into the host computer.
IMPORTANT: Check the README file for your operating system before you
install the software.
2. Install the SAM software. See Installing the Service and Assembly Module
(SAM) Software on page A-2.
2-1