Appendix D-2: Determining And Setting The Trigger Points - Kodak HR 500 Operator's Manual

Using the Long Roll Accessory
Appendix D-2: Determining and Setting the Trigger
Points
plastic cover
D-34
IMPORTANT: Do this procedure only if you will be scanning film that has a
significantly higher or lower D-min from negative film, such as
black-and-white film or color positive film.
1. With the PC powered off, power on the scanner.
2. Wait for the series of 3 beeps to sound at the scanner (or for the lamp to
illuminate).
3. Power on the PC.
Recording the Highest Numbers on the LEDs
IMPORTANT: There must not be film in the scanner.
1. Open the plastic cover.
2. Look at the red LED number on the right side of the Long Roll Accessory.
Note this number as being the "highest" number on the right side.
3. Look at the red LED number on the left side. Note this number as being the
"highest" number on the left side.
TEACH ADJ MODE
SET RUN L D
P192_1566BCA
August 2001
P192_1566BC