Open Caveats; Resolved Caveats - Cisco 7921G Release Notes

Open caveats

Open caveats
The following table lists severity 1, 2, and 3 defects that are open for the Cisco Unified IP Phones that use
Firmware Release 1.4(4).
For more information about an individual defect, you can access the online record for the defect by clicking
the Identifier or going to the URL that is shown. You must be a registered Cisco.com user to access this online
information.
Because defect status continually changes, the table reflects a snapshot of the defects that were open at the
time this report was compiled. For an updated view of open defects, access Bug Toolkit as described in
Cisco Software Bug Toolkit, on page
Table 1: Open caveats for firmware Release 1.4(4)
Identifier
CSCtt38270
CSCud75168

Resolved caveats

The following table lists severity 1, 2, and 3 defects that are resolved for the Cisco Unified IP Phones that use
Firmware Release 1.4(4).
For more information about an individual defect, you can access the online record for the defect by clicking
the Identifier or going to the URL that is shown. You must be a registered Cisco.com user to access this online
information.
Because defect status continually changes, the table reflects a snapshot of the defects that were open at the
time this report was compiled. For an updated view of open defects, access Bug Toolkit as described in
Cisco Software Bug Toolkit, on page
Table 2: Resolved Caveats for Firmware Release 1.4(4)
Identifier
CSCtz46981
CSCua00975
CSCub51804
CSCub55137
Cisco Unified Wireless IP Phone 7921G, 7925G, 7925G-EX, and 7926G Release Notes for Firmware Release
1.4(4)
10
Cisco Unified Wireless IP Phone 7921G, 7925G, 7925G-EX, and 7926G Release Notes for Firmware Release 1.4(4)
9.
Headline
7925 sometimes takes 1+ second to respond to WPA M1 key message
7925 becomes unresponsive when terminating silent recording session
9.
Headline
792x on 2.4 GHz utilizes QBSS for roaming decisions
792x phone is not sending TSPEC for call control (UP4)
Intermittent hanging of splash screen
792x sometimes does not use the source port defined in SCCP
OpenReceiveChannelAck
Access
Access