Assembling And Hanging The Fan - Hunter Type 5 Models Owner's Manual And Installation Manual

WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3.1 Unbundle the wires from the fan.
For Standard or Angled mounting:
3.2 Insert the downrod through the canopy and canopy trim ring.
Feed the wires from the fan through the downrod on one side of
the pin in the ball.
3.3 Loosen the square head setscrew on the adapter to install the pipe
and ball assembly. Note: When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is normal.
Securely retighten the setscrew with a wrench or pliers. Skip to
step 3.7.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
Hanging the Fan:
3.4 Raise the fan and place the hook on the ceiling plate through the
round hole in the canopy.
3 • Assembling and Hanging the Fan 3 • Assembling and Hanging the Fan
8
42216-01 • 05/02/12 • Hunter Fan Company
Standard or Angled Mounting
Steps 3-2 – 3-3
Step 3-4
Downrod
Canopy
Setscrew
Round Hole