Connection And Setup; Setting Up To Display In Hd; Connecting To Your Telus Satellite Tv Antenna - TELUS Salellite TV User Manual

Connection and setup

Setting up to display in HD

If you have subscribed to HD programming, use the following steps to select the desired HDTV format .
1
Press to open the main menu .
2
System Setup
Use to highlight
3
Use to highlight HDTV Setup
4
Use to highlight the HD Format Settings
5
Aspect Ratio
Use to highlight the
16:9 is the setting for widescreen HDTV display .
6
Done
Press to highlight
7
If required, set up your HDTV to display in the format you desire . Some HDTVs will automatically adjust to the resolution setting on your receiver .

Connecting to your TELUS Satellite TV antenna

Before you can begin connecting your receiver to your TELUS Satellite TV antenna, you must first complete the previous sections on
connecting your TV to the receiver .
1
Connect 2 RG-6 coaxial cables between the Satellite In 1 and Satellite In 2 ports on the receiver' s back panel to 2 available ports on
either the switch or LNBF in your existing system .
2
Press to open the main menu, highlight
on the TV .
3
Check Switch . Select
Select
4
The receiver begins performing the check switch tests . When it' s finished, the installation summary screen displays .
5
Make sure that the information on the installation summary screen identifies your system correctly and shows all transponders for all
satellites in your system .
6
Select OK to go to the Point Dish screen .
7
Cancel
Select to exit the point dish menu . At this point, the receiver may start downloading software . If it does, follow the onscreen
instructions and don't use the receiver until the process is complete . Otherwise, press
able to view your programming .
and press .
and press .
that match the format that your TV supports and press
option that matches your TV and press
4:3 #1 is the setting to use on a 4:3 TV that uses
vertical compression . When displaying a 16:9 feed, the
picture will show black bars on the top and bottom of
the screen .
and press .
System Setup, then Installation, and then
T est .
.
. Y ou can choose between the following options:
4:3 #2 is the setting to use on a 4:3 TV that does not
have internal vertical compression . When displaying a
16:9 feed, the picture will appear tall and skinny .
Point Dish
to display the Point Dish screen
. After a few minutes, you should be
16