The following table describes the parameters in this page:
Field
Country
Select the country you are in.
ISP
Select your Internet Service Provider (ISP).
Virtual path identifier (VPI) is the virtual path between two
VPI
points in an ATM network. Its valid value is between 0 and
255. Enter the correct VPI provided by your ISP.
Virtual channel identifier (VCI) is the virtual channel between
VCI
two points in an ATM network. Its valid value is between 1
and 65535. Enter the correct VCI provided by your ISP.
Select a connection type from the dropdown list. You may
Connection
select PPPoE/ PPPoA/ Dynamic IP/ Static IP/ Routered IP/
Type
Bridge.
5.3.2.
Bridge Mode
Select Bridge Mode, click NEXT, and the page shown in the following figure
will appear.
Description
43