Nat - Edimax AR-7286WnA User Manual

The following table describes the parameters and buttons of this page:
Field
Destination Enter the IP address of the destination device.
IP Address
IP Subnet Enter the subnet mask of the destination device.
Mask
Gateway IP You can enter the IP address of the next hop in the IP route to
Address the destination device, or bind with a PVC interface.
Metric The metric cost for the destination.
This parameter determines if the ADSL router will include the
route to this remote node in its RIP broadcasts. If set to Yes,
Announced
the route to this remote node will be propagated to other
in RIP
hosts through RIP broadcasts. If No, this route is kept private
and is not included in RIP broadcasts.
5.5.3.

NAT

Click Advanced Setup > NAT, the page shown in the following figure appears.
In this page, you can set up the NAT (Network Address Translation) function
for your ADSL router. This function allows you to share one WAN IP address
for multiple computers on your LAN.
The following table describes the parameters and buttons of this page:
Field
Virtual Choose a Virtual Circuit Index to set up for the NAT function.
Circuit
This field shows the current NAT status for the current VC. The
NAT Status status is enabled or disabled, depending on whether NAT is
enabled for the WAN connection.
Description
Description
65